The CR-150-BOX is an unpainted die-cast aluminum housing intended for use with the CR-150 evaluation test board. Using the CR-150-BOX will simplify the task of electrically shielding the CR-150 evaluation test board and the associated charge sensitive preamplifier (CSP). Holes have been positioned on the CR-150-BOX in locations associated with BNC connector positions (detector bias, preamplifier output, and test pulser input) and banana connector positions (-12V, GND, +12V) on the CR-150 board. There is also a hole on the opposite side of the box to apply a ’panel-mount’ BNC connector, which can be connected to the input (detector) terminal of the CR-150 board via a soldered wire connection. A panel mountable BNC connector is supplied for this purpose.

The CR-150-BOX has outer dimensions of 4.6 inches (width) x 3.6 inches (depth) x 2.2 inches (height). The CR-150 evaluation board and preamplifier modules are sold separately.

Use only with CSPs

The CR-150 evaluation board is intended for use only with Cremat's charge sensitive preamplifiers.

The CR-200 series of shaping amplifiers have their own evaluation board (CR-160) and should not be plugged into the CR-150.